Bihler BIMERIC BM punching, bending and assembly system electronic cams move the different units.

Bihler BIMERIC BM punching, bending and assembly system electronic cams move the different units.

Bihler BIMERIC BM punching, bending and assembly system electronic cams move the different units.

Flexibility will be the keyword for the efficient production of small batches and component variants in the future. In the new BIMERIC BM punching, bending and assembly system electronic cams move the different units. Under the motto "Plug & Work", servo drives generate all the work cycles flexibly and independently of each other by means of a numerical control system. The advantages of numerical control over mechanical control lie not only in the economic production of large batches or in the flexibility of the software, but also in the automatic readjustment of units for enhanced quality assurance.

Technical Data BM 3xx

Stroking rate

steplessly up to 250 cycles/min.

Press

Two-point eccentric press 150kN (15 Mp),

stroke 8 mm

Slide unit

max. nominal forming capacity 25kN (2,5 Mp),

max. stroke 60 mm

Feed length

gripper feed : max. 250 mm

roller feed: unlimited

Material

max. strip width 40 mm

Modules

BM 303 basic module 3

BM 306 basic moduel 6

BM 309 module 3 and 6

BM 312 module 6 2x